CADability dotNET
The SnapPointFinder type exposes the following members.
Methods
| Name | Description | |
|---|---|---|
 | Accept | |
| Check |
The IGeoObject obj offers the point p as a snappoint in the given mode.
This method checks whether to use this point as the closest snap point.
This method is typically called by GeoObjects from the FindSnapPoint(SnapPointFinder) method.
|
| Init(Point, Projection, SnapPointFinder..::..SnapModes, Int32) | |
| Init(Point, Projection, SnapPointFinder..::..SnapModes, Int32, GeoPoint) | |
| SnapHierarchy |
