Empty constructor, must be called when a derived object is constructed.

Constructor required by deserialization

Overrides IGeoObjectImpl.Clone()()()() and implements IGeoObject.Clone()()()().

The only way to construct a hatch object. If a Constructor is registered, this constructor will be used, if not a Hatch object is created.

Overrides IGeoObjectImpl.CopyGeometry(IGeoObject) and implements IGeoObject.CopyGeometry(IGeoObject).

Overrides Decompose()()()()

Overrides IGeoObjectImpl.Get2DRepresentation(Projection, GDIResources) and implements IGeoObject.Get2DRepresentation(Projection, GDIResources).

Overrides IGeoObjectImpl.GetAttributeProperties(IFrame) and implements IGeoObject.GetAttributeProperties(IFrame).

Overrides GetBoundingCube()()()()

Overrides GetExtent(Double)

Overrides GetExtent(Projection, ExtentPrecision)

Implements ISerializable:GetObjectData

Overrides GetQuadTreeItem(Projection, ExtentPrecision)

Overrides IGeoObjectImpl.GetShowProperties(IFrame) and implements IGeoObject.GetShowProperties(IFrame).

Overrides HitTest(BoundingCube%, Double)

Overrides HitTest(Projection, BoundingRect, Boolean)

Overrides IGeoObjectImpl.IsAttributeUsed(Object) and implements IGeoObject.IsAttributeUsed(Object).

Overrides IGeoObjectImpl.Modify(ModOp) and implements IGeoObject.Modify(ModOp).

Overrides PaintTo3D(IPaintTo3D)

Overrides PaintTo3DList(IPaintTo3D, ICategorizedDislayLists)

Overrides Position(GeoPoint, GeoVector, Double)

After the HatchStyle, the CompoundShape or the HatchStyle has been modified this method must be called to calculate the new contents.

Factory mechanism for constructing Hatch objects If you have a class derivec from this class (Hatch) and everytime CADability creates a hatch object your object should be created, you have to register your static construct method here.

The HatchStyle that defines the interior of this object

The Plane which defines the 3d position of the CompoundShape.